SS SHEET & PLATE SPECIFICATIONS
|SHEETS & PLATES||SPECIFICATIONS|
Shim Sheet, Perforated Sheet (Round, Square & Oblong Hole) & as per your Drawing
ASTM A240, A480, A167
0.1 mm to 100 mm thick upto 2500 mm width & upto 8000 mm length available with NACE MR 01-75s.
Hot Rolled(HR), Cold Rolled(CR), 2B, 2D, BA, NO. 1, NO. 4, NO.8, 8K, Mirror, Checkered, Embossed, Hair Line, Sand Blast, Brush, Etching
ASTM /ASME A/SA 213 / 249 / 269 / 312 / 358 CL. I to V - 304 , 304L , 304H, 309S ,309H , 310S, 310H , 316 , 316TI , 316H , 316 LN , 317 , 317L , 321 , 321H , 347 , 347 H , 904L .
ASTM/ASME A/SA 789, 790 - UNS NO S 31803 , S 32205 , S 32550 , S 32750 , S 32760.
Nickel Alloys 200, Nickel Alloys 201
Hastelloy C-22, Hastelloy C-276, Hastelloy C-2000, Hastelloy C-4, Hastelloy X, Hastelloy B, Hastelloy N, Hastelloy G
Inconel 600, Inconel 601, Inconel 625, Inconel 625LCF, Inconel 686, Inconel 718, Inconel 800, Inconel 825, Inconel X-750 , Inconel 690, Inconel 602, Inconel 617, Inconel 925, Inconel A-289, Inconel AL-6XN, AL-904L
TYPES OF SS SHEETS
Bright annealing finish obtained by a secondary light process which polishes rolls after No.2D is finished. It is most suitable for deep drawing that is not so severe. Polishing No.2D is even easier than before even after fabrication. It is recommended for this application to be done with (not limited to): medical equipment, milk tanks, cooking appliances, tableware and structural members
Very attractive finish by means of a heating treatment in an inert atmosphere furnace and then under goes a light cold process using polishing rolls after cold rolling. Due to its attractive finish, the BA finish is suitable for various decorative items and applications requiring unimpaired surface attractiveness after light fabrication. For pressed and formed products, simple buff-polishing can provide them with luster
Comparatively rough polished finish (100-120 mesh). It is recommended for applications in which a semi-polished finish of the surface is required, such as jacket exterior of milk equipment and kitchen counter tops
General polished finish, obtained by finalized polishing agents 150-180 mesh after No.2B finishes. It offers a uniform and attractive appearance. Commonly the product of the No.4 finish is used as is, but further high-grade finishes can be applied if required. The finish is clean and sanitary; it is suitable for milk and food processing equipment and medical equipment
Finish in which continuous abrasion lines are added to the No.4 finish. Repair after welding is easy and recommended. It is suitable for structural and similar applications